On sale!
-50%

NV-Tone Swan NT (Integrated)

NV-Tone TSwan NT (Integrated) This is a pickup with a condenser microphone for acoustic and classical guitars, allowing you to capture a wide spectrum of the instrument's sound while boasting excellent feedback resistance. The simple installation requires minimal modifications to the instrument. Thanks to the secure mounting and the optimal length of the microphone's flexible gooseneck, you can choose any position you prefer.

$159.00 $318.00 -50%

No tax

The item is in stock in the USA. The cost does not include shipping, VAT, and customs duties in your country. For individual inquiries, please contact support.

Equipment:

The microphone is aluminum with a flexible neck
Reliable and secure mounting for your instrument (velvet coating)
XLR inverter connector
High-quality 5-meter (16.4 ft) audio cable, one end with a stereo jack, the other end with an XLR connector
Integrated installation kit, stereo endpin with strap mount

DEMO SOUND 1

DEMO SOUND 2

DEMO SOUND 3

it is recommended to listen with headphones

Bracket body: Polycarbonate
Cable length: 5m (16.4 ft)
Frequency range: 20 ~ 20000 Hz
Sensitivity: -32 ±3 dB
Signal-to-noise ratio: 74 dB
Operating voltage range: 1 ~ 10 VDC
Neck length: 12 cm (4.72 inch)
Directivity: omni-directional
Material: aerospace-grade 6061 aluminum

Brand

Installation and operation manual

For External Only

Unwind the cable, select the direction for a left-handed or right-handed guitar on the pickup, and secure the cable in the appropriate place.
Loosen the screws of the pickup slightly.
Place the pickup into the resonator hole and tighten the screws.
Connect the XLR connector to the microphone input of your combo, mixer, audio interface, etc.
Turn on the Phantom power if it is not enabled by default.

For internal only

Remove the strap lock from your instrument at the bottom of the guitar if it is there (we recommend this location for installing the endpin).
Make a hole with a drill or router with a diameter of 12 mm / 15/32 inches.
Secure the endpin with a nut and a locknut (adjusting the length of the output beforehand).
Select the direction for a left-handed or right-handed guitar on the pickup and secure the cable in the appropriate place.
Loosen the screws of the pickup slightly.
Place the pickup into the resonator hole and tighten the screws.
Connect the stereo jack to the socket in the guitar.
Connect the XLR connector to the microphone input of your combo, mixer, audio interface, etc.
Turn on the Phantom power (+48) if it is not enabled by default.